FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS ISO 22090-2:2014 2014This part of ISO 22090 specifies the construction, performance, and testing of a device employing only magnetic means as transmitting heading devices required by chapter V, SOLAS 1974 (as amended). A Transmitting Heading Device (THD) is an electronic device that provides information about the ship’s true heading. In addition to the general requirements contained in IMO Resolution A.694(17) to which IEC 60945 is associated and the relevant standard for the sensing part used, the THD equipment shall comply with the following minimum requirements. Where the IMO performance standards which apply to the sensing part do not specify a geographical operating area the THD shall operate
The THDs complying with the requirements contained in this part of ISOÂ 22090 can be used for heading information as contained in chapter V of the SOLAS Convention. In addition such THDs are intended to meet the dynamic requirements contained in the HSC Code, chapter 13 for the carriage of a suitable device providing heading information.
A standard magnetic compass with a pickup sensor could be applied as a sensing part of this standard of geomagnetic principle. However the IMO performance resolution MSC.116(73) requires that the THD is intended to be met for the dynamic requirements of the HSC code. Nevertheless, when the THD would be only used other than the HSC, the limit of rate of turn may be 6 °/s instead of 20 °/s.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|