FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS EN 1028-1:2002+A1:2008 2008This standard applies for centrifugal pumps with priming devices for fire-fighting use supplied separately without driver and couplings. Fire-fighting centrifugal pumps with primer are defined as terminated by their inlet and outlet connections as well as by their shaft ends. This standard applies for fire-fighting centrifugal pumps with priming devices for use under ambient temperatures between -15 °C and 40 °C.
This standard does not apply to fire-fighting centrifugal pumps with primer of which the only power source is directly applied manual effort. This standard specifies the classification and general requirements for fire-fighting centrifugal pumps with priming devices with a nominal delivery rate of up to 6000 l/min. This standard deals with significant hazards listed in clause 4, hazardous situations and events during the commissioning, operation and maintenance of fire-fighting centrifugal pumps with priming devices, used as intended and under the conditions foreseen by the manufacturer or the manufacturer's authorized representative. In addition, fire-fighting centrifugal pumps with priming devices shall conform as appropriate to EN 292 for hazards not covered by this standard. This standard does not deal with the detailed verification of general and safety requirements and/or protective measures. These are covered in EN 1028-2 "Verification of general and safety requirements". This standard does not deal with the technical safety requirements for the design or manufacture of drivers or of auxiliary equipment. It does not cover risks directly arising from means provided for the portability, transportability, and mobility of pump units during or between periods of operation, or requirements for transmission shafts linking selfpropelled machinery to a pump. In addition, this standard does not cover:
This standard does not apply to fire-fighting centrifugal pumps with primer that are manufactured before the date of publication by CEN of this standard.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|