|
FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of 23/30455835 DC 2023(1) EN 1991-1-1 gives rules on the following aspects related to actions, which are relevant to the structural design of buildings and civil engineering works including some geotechnical aspects: - specific weight of construction materials and stored materials; - self-weight of construction works; - imposed loads for buildings. (2) Mean values for specific weight of specific construction materials, additional materials for bridges, stored materials and products are given. In addition, for specific materials and products the angle of repose is provided. (3) Methods for the assessment of the characteristic values of self-weight of construction works are given. (4) Characteristic values of imposed loads are given for the following areas in buildings according to the category of use: - residential, social, commercial and administration areas; - areas for archive, storage and industrial activities; - garage and vehicle traffic areas (excluding bridges); - roofs; - stairs and landings; - terraces and balconies. NOTE The loads on traffic areas given in this standard refer to vehicles up to a gross vehicle weight of 160 kN. Further information can be obtained from prEN 1991-2:2021. (5) Characteristic values of horizontal loads on parapets and partition walls acting as barriers are provided. NOTE Forces due to vehicle impact are specified in EN 1991-1-7 and prEN 1991-2:2021. 1.2 Assumptions (1) The general assumptions of FprEN 1990:2022 apply. (2) EN 1991-1-1 is intended to be used with EN 1990, the other Parts of EN 1991 and the other Eurocode parts for the design of structures.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|