|
FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis standard describes the materials and application of prefabricated polyolefin tape coating systems in coating plants at fixed sites using coating techniques and equipment as recommended by the tape coating manufacturer. For normal construction considerations, tape coatings are applied as a three-layer system consisting of (1) liquid adhesive, (2) corrosion-preventive tape (inner layer), and (3) mechanical-protective tape (outer layer). It establishes the minimum requirements for tape coating systems used on the exterior of steel water pipes. Continuous monitoring of application procedures for the tape coating systems shall be performed by the applicator. 1.1.1 Maximum temperatures. AWWA pipe coating standards are written for and based on the service temperature of potable water. These coating systems have performed at higher temperatures. Consult the coating manufacturer for conditions and limitations. 1.1.2 Conditions not described in this standard. This standard does not describe the additional materials and procedures that may be required for difficult conditions, such as those encountered in rocky areas or where soil conditions are known to be severe and in construction of underwater lines, casing pipe, and river crossings outside the scope of ANSI/AWWA C214. The manufacturer should be consulted for specific recommendations when these conditions exist.Subscription InformationMADCAD.com AWWA Standards & Manuals subscriptions are annual and access is concurrency based (number of people that can access the subscription at any given time).
Some features of MADCAD.com AWWA Standards & Manuals Subscriptions are:
- Floating concurrency model: Set your concurrency level and share your AWWA Standards & Manuals Subscriptions among your offices enterprise-wide.
- Immediate Access: As soon as the transaction is completed, your AWWA Standards & Manuals Subscription will be ready for access.
For any further information on MADCAD.com AWWA Standards & Manuals Subscriptions, please contact us at info@madcad.com or +1 800.798.9296.
About AWWAEstablished in 1881, the American Water Works Association is the oldest and largest nonprofit, scientific and educational organization dedicated to safe and sustainable water in the world. With more than 50,000 members worldwide and 43 Sections in North America, AWWA advances public health, safety and welfare by uniting the efforts of the entire water community. AWWA Offers education to water professionals Advocates for safe and sustainable water Collects and share knowledge Creates volunteering opportunities |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|