1. Scope

1.1 This specification covers thermoplastic elastomeric seals (gaskets) used to seal the joints of plastic pipe and fittings used for gravity and low-pressure applications. This specification refers to push-on joints that require no internal or external pressure to effect the initial seal.

1.2 Requirements are given for thermoplastic elastomers.

1.3 The values in SI units are to be regarded as standard. The values given in parentheses are mathimatical conversions to inch-pound units which are provided for information only and are not considered the standard.

The following precautionary caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

D471 Test Method for Rubber Property--Effect of Liquids

D573 Test Method for Rubber--Deterioration in an Air Oven

D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment

D1414 Test Methods for Rubber O-Rings

D1566 Terminology Relating to Rubber

D1600 Terminology for Abbreviated Terms Relating to Plastics

D2240 Test Method for Rubber Property--Durometer Hardness

D6147 Test Method for Vulcanized Rubber and Thermoplastic Elastomer--Determination of Force Decay (Stress Relaxation) in Compression

F118 Definitions of Terms Relating to Gaskets

F412 Terminology Relating to Plastic Piping Systems

Keywords

elastomeric; joining; piping; seals; thermoplastic; Elastomeric seals/sealants--specifications; Gaskets--specifications; Joining plastic pipe/tubing/fittings; Reinforced thermosetting resin (RTR) seals--specifications; Sewer pipe (thermoplastic)--specifications; Thermoplastic pipe/tube/fittings--specifications; Water supply/distribution systems--specifications;

ICS Code

ICS Number Code 23.040.80 (Seals for pipe and hose assemblies)

DOI: 10.1520/F0913-02E01

ASTM International is a member of CrossRef.