ASTM F585-94(2007)
Historical Standard: ASTM F585-94(2007) Standard Practice for Insertion of Flexible Polyethylene Pipe Into Existing Sewers
SUPERSEDED (see Active link, below)
ASTM F585
1. Scope
1.1 This practice describes design and selection considerations and installation procedures for the construction of new sanitary and storm sewers by the insertion of polyethylene pipe through existing pipe and along the previously existing line and grade. The procedures are designed to minimize traffic disruption, surface damage, and restoration, with little or no interruption of service.
Note 1See CGSB 41-GP-25M.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D543 Practices for Evaluating the Resistance of Plastics to Chemical Reagents
D1600 Terminology for Abbreviated Terms Relating to Plastics
D2657 Practice for Heat Fusion Joining of Polyolefin Pipe and Fittings
D3350 Specification for Polyethylene Plastics Pipe and Fittings Materials
F412 Terminology Relating to Plastic Piping Systems
F714 Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter
F894 Specification for Polyethylene (PE) Large Diameter Profile Wall Sewer and Drain Pipe
Keywords
conduit; insertion renewal; polyethylene pipe; rehabilitation; sanitary sewer; sliplining; storm sewer; trenchless;
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/F0585-94R07
ASTM International is a member of CrossRef.
