ASTM F410-95
Historical Standard: ASTM F410-95 Standard Test Method for Wear Layer Thickness of Resilient Floor Coverings by Optical Measurement
SUPERSEDED (see Active link, below)
ASTM F410
1. Scope
1.1 This test method covers the determination of the thickness of the wear layer of resilient non-textile floor coverings, in tile or sheet form, with or without felt backing or foam layer, by optical measurement.
1.2 This test method is applicable for wear layers with a minimum thickness of 0.0004 in. (0.01 mm) to a maximum thickness of 0.1 in. (2.54 mm), where measurements within 0.0001 in. or 0.0025 mm are tolerable.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
measurement; optical; resilient; test; thickness; wear layer; Microscopic examination; Optical materials/properties/tests; Resilient flooring; Thickness--resilient floor coverings;
ICS Code
ICS Number Code 97.150 (Non-textile floor coverings)
DOI: 10.1520/F0410-95
ASTM International is a member of CrossRef.
