ASTM F2649-08
Historical Standard: ASTM F2649-08 Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks
SUPERSEDED (see Active link, below)
ASTM F2649
1. Scope
1.1 This specification covers material, design, structural performance, and manufacturing practice requirements for monolithic or sectional corrugated polyethylene grease interceptor tanks with volumes equal to or greater than 333 gallons (1,260 liters ).
1.2 The corrugated high density polyethylene (HDPE) grease interceptor tanks are placed between commercial food service (kitchen) drains and sanitary sewer interceptors to minimize the impact of commercial food service effluent containing grease, oils, soap scum and other typical commercial food service wastes on the sanitary sewer system. Typical sources of commercial kitchen effluent are scullery sinks, pot and pan sinks, dishwashers, soup kettles and floor drains where grease containing materials may exist.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This specification covers pipe and fittings for horizontally laid corrugated HDPE grease interceptor tanks as illustrated in Fig. 1.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D543 Practices for Evaluating the Resistance of Plastics to Chemical Reagents
D1600 Terminology for Abbreviated Terms Relating to Plastics
D3212 Specification for Joints for Drain and Sewer Plastic Pipes Using Flexible Elastomeric Seals
D3350 Specification for Polyethylene Plastics Pipe and Fittings Materials
F412 Terminology Relating to Plastic Piping Systems
F477 Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe
F667 Specification for 3 through 24 in. Corrugated Polyethylene Pipe and Fittings
F714 Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter
F2306/F2306M Specification for 12 to 60 in. [300 to 1500 mm] Annular Corrugated Profile-Wall Polyethylene (PE) Pipe and Fittings for Gravity-Flow Storm Sewer and Subsurface Drainage Applications
IAPMO Document
IAPMO/ANSIZ1001 Prefabricated Gravity Grease InterceptorsAmerican Society of Civil Engineers
ASCENo.60 Gravity Sanitary Sewer Design and ConstructionAASHTO Document
AASHTOLRFD Bridge SpecificationsKeywords
corrugated HDPE pipe; grease interceptor tanks; liquid kitchen waste; wastewater pretreatment; Grease interceptor tanks; HDPE (high-density polyethylene); Wastewater testing/treatment--specifications;
ICS Code
ICS Number Code 21.260 (Lubrication systems)
DOI: 10.1520/F2649-08
ASTM International is a member of CrossRef.