ASTM F2285-04
Historical Standard: ASTM F2285-04 Standard Consumer Safety Performance Specification for Diaper Changing Tables for Commercial Use
SUPERSEDED (see Active link, below)
ASTM F2285
1. Scope
1.1 This consumer safety specification establishes safety performance requirements, test methods, and labeling requirements to minimize the hazards to children presented by diaper changing tables as identified in the introduction.
1.2 This specification is intended to apply to diaper changing tables for commercial use. It is intended for use with children up to 50 lbs.
1.3 No diaper changing table produced after the approval date of this consumer safety performance specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements herein.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D3359 Test Methods for Measuring Adhesion by Tape Test
Federal Standards
16CFR1501 Method for Identifying Toys and Other Articles Intended for Use by Children Under Three Years of Age Which Present Choking, Aspiration, or Ingestion Hazards Because of Small PartsOther Documents
CAMIInfantDummy,Mark (see )Keywords
diaper changing table; tables; Consumer products--specifications; Consumer safety specifications (bathrooms); Baby changing tables;
ICS Code
ICS Number Code 97.190 (Equipment for children)
DOI: 10.1520/F2285-04
ASTM International is a member of CrossRef.
