1. Scope

1.1 This specification covers requirements for ferrous and nonferrous inch balls. The balls covered in this specification are intended for use in bearings, bearing applications, check valves, and other components using balls.

1.2 This is a general specification. The individual item requirements shall be as specified herein in accordance with the Annex A2 through Annex A9 MS sheet standards. In the event of any conflict between requirements of this specification and the Annex A2 through Annex A9 MS sheet standards, the latter shall govern.

1.3 The values given in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This specification contains many of the requirements of MIL-B-1083, which was originally developed by the Department of Defense and maintained by the Defense Supply Center Richmond. The following government activity codes may be found in the Department of Defense, Standardization Directory SD-1.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A108 Specification for Steel Bar, Carbon and Alloy, Cold-Finished

A276 Specification for Stainless Steel Bars and Shapes

A295 Specification for High-Carbon Anti-Friction Bearing Steel

B21/B21M Specification for Naval Brass Rod, Bar, and Shapes

B124/B124M Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes

B276 Test Method for Apparent Porosity in Cemented Carbides

B283 Specification for Copper and Copper-Alloy Die Forgings (Hot-Pressed)

D3951 Practice for Commercial Packaging

E18 Test Methods for Rockwell Hardness of Metallic Materials

E112 Test Methods for Determining Average Grain Size

E381 Method of Macroetch Testing Steel Bars, Billets, Blooms, and Forgings

E384 Test Method for Knoop and Vickers Hardness of Materials

Federal Standards

ISO Standard

ANSI Standards

Keywords

ball bearing; ball valve; bearing; bearing accessories; bearing rolling elements; Aircraft-quality steel balls; Aluminum bronze balls; Ball/roller bearings--specifications; Ball valve; Bearing materials--specifications; Beryllium copper balls; Brass balls; Bronze balls; Check valves; Corrosion-resistant steel--specifications; Ferrous inch balls; Nickel-copper alloy steel--specifications; Nonferrous inch balls; Silicon molybdenum steel balls; Tungsten carbide; UNS G51986 (Cr alloy steel); UNS C46400 (naval brass, uninhibited); UNS G10080 (carbon steel); UNS G10220 (carbon steel); UNS G52986 (Cr alloy steel); UNS S44003 (hardenable Cr stainless steel); UNS S44004 (hardenable Cr stainless steel); UNS T11350 (bearing steel) ;

ICS Code

ICS Number Code 23.060.20 (Ball and plug valves)

DOI: 10.1520/F2215-03E01

ASTM International is a member of CrossRef.