ASTM F1909-98(2004)
Historical Standard: ASTM F1909-98(2004) Specification for Preformed Open-Cell Sponge Rubber Pail and Drum Gaskets
SUPERSEDED (see Active link, below)
ASTM F1909
1. Scope
1.1 This specification covers preformed open-cell sponge rubber gaskets of the following classes for use in new or reconditioned pails or drums.
1.1.1 Class ANon-Oil Resistant.
1.1.2 Class BOil Resistant.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 The following safety hazards caveat pertains only to Section 10, General Test Methods. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1ISO Equivalency Statement- This proposed specification was found to be not equivalent .
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D395 Test Methods for Rubber Property--Compression Set
D471 Test Method for Rubber Property--Effect of Liquids
D573 Test Method for Rubber--Deterioration in an Air Oven
D575 Test Methods for Rubber Properties in Compression
D1056 Specification for Flexible Cellular Materials--Sponge or Expanded Rubber
D3182 Practice for Rubber--Materials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets
D3183 Practice for Rubber--Preparation of Pieces for Test Purposes from Products
Keywords
gaskets; rubber; sponge;
ICS Code
ICS Number Code 83.140.50 (Seals)
DOI: 10.1520/F1909-98R04
ASTM International is a member of CrossRef.
