Abstract

This specification establishes the construction, coding, and performance requirements for self-contained, globe style, pressure-reducing valves used in water systems of shipboard installations that are limited to discharge pressure settings of 200 psig (1379 kPa) and below. The valves shall be either the pressurized spring chamber type (Type I) or unpressurized spring chamber type (Type II). They shall be tested for their conformance with hydrostatic proof, seat tightness, set pressure limits, and capacity.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers self-contained, globe style, pressure-reducing valves for use in water systems of shipboard installations. These valves are limited to discharge pressure settings of 200 psig (1379 kPa) and below.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The following precautionary caveat pertains only to the tests portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A125 Specification for Steel Springs, Helical, Heat-Treated

A193/A193M Specification for Alloy-Steel and Stainless Steel Bolting for High Temperature or High Pressure Service and Other Special Purpose Applications

A194/A194M Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both

A231/A231M Specification for Chromium-Vanadium Alloy Steel Spring Wire

A276 Specification for Stainless Steel Bars and Shapes

A313/A313M Specification for Stainless Steel Spring Wire

A689 Specification for Carbon and Alloy Steel Bars for Springs

B21/B21M Specification for Naval Brass Rod, Bar, and Shapes

B26/B26M Specification for Aluminum-Alloy Sand Castings

B61 Specification for Steam or Valve Bronze Castings

B62 Specification for Composition Bronze or Ounce Metal Castings

B148 Specification for Aluminum-Bronze Sand Castings

B150/B150M Specification for Aluminum Bronze Rod, Bar, and Shapes

B637 Specification for Precipitation-Hardening and Cold Worked Nickel Alloy Bars, Forgings, and Forging Stock for Moderate or High Temperature Service

B689 Specification for Electroplated Engineering Nickel Coatings

F467 Specification for Nonferrous Nuts for General Use

F468 Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use

F593 Specification for Stainless Steel Bolts, Hex Cap Screws, and Studs

F594 Specification for Stainless Steel Nuts

ANSI Standards

ISA Standards

Keywords

Globe-style valves; Marine systems/subsystems/equipment--specifications; Pressure-reducing valves; Shipbuilding piping materials--specifications; Shipbuilding steel pipe materials--specifications; Valves--marine vessels;

ICS Code

ICS Number Code 23.060.40 (Pressure regulators); 47.020.30 (Piping systems)

DOI: 10.1520/F1370-92R11

ASTM International is a member of CrossRef.

ASTM F1370