ASTM F1041-95
Historical Standard: ASTM F1041-95 Standard Guide for Squeeze-Off of Polyolefin Gas Pressure Pipe and Tubing
SUPERSEDED (see Active link, below)
ASTM F1041
1. Scope
1.1 This guide describes general procedures for squeeze-off of polyolefin gas pressure pipe and tubing. Pipe and squeeze tool manufacturers should be requested to supply specific recommendations for squeeze-off with their materials or products.
1.2 Governing codes and project specifications should be consulted. Nothing in this document should be construed as recommending practices or systems at variance with governing codes and project specifications.
1.3 This guide covers squeeze-off of polyolefin pipe and tubing in accordance with Specification D2513.
1.4 Where applicable in this guide, 'pipe' shall mean 'pipe and tubing'.
1.5 The values as stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only.
1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D2513 Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings
F1734 Practice for Qualification of a Combination of Squeeze Tool, Pipe, and Squeeze-Off Procedures to Avoid Long-Term Damage in Polyethylene (PE) Gas Pipe
Other Standards
GRI-92/0147.2 Volume 2: Technical Reference on Squeeze-off of Polyethylene Gas Pipes GRI Document Fulfillment Center, 1510 Hubbard Dr. Batavia, IL 60510.Keywords
damage; pipe; polyolefin; squeeze-off; Compression testing--plastics; Emergency procedures; Force; Gases; Gas pressure systems/applications; Hydraulic devices; Mechanical devices; Oversqueeze protection; Polyolefin (PO) pipe/fittings; Premature release protection; Pressure pipelines/piping systems; Safety precautions; Squeeze-off materials/applications;
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/F1041-95
ASTM International is a member of CrossRef.
