Significance and Use

Squeeze-off is a technique used to control the flow of gas through a pipe by the compressing action of a mechanical or hydraulic device. Squeeze-off may be used to reduce the flow of gas to an acceptable rate.

Proper squeeze-off procedures result in significant time saving in the reduction of gas flow in an emergency and in the maintenance and operation, or both, of a gas distribution system. Improper squeeze-off can cause damage to the pipe or create a safety hazard, or both.

1. Scope

1.1 This guide describes general procedures for squeeze-off of polyolefin gas pressure pipe and tubing. Pipe and squeeze tool manufacturers shall be requested to supply recommendations for squeeze-off with materials or products.

1.2 Governing codes and project specifications should be consulted. Nothing in this document should be construed as recommending practices or systems at variance with governing codes and project specifications.

1.3 This guide covers squeeze-off of polyolefin pipe and tubing in accordance with Specification D 2513 .

1.4 Where applicable in this guide, pipe shall mean pipe and tubing.

1.5 Units The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered the standard.

1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D2513 Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings

F1734 Practice for Qualification of a Combination of Squeeze Tool, Pipe, and Squeeze-Off Procedures to Avoid Long-Term Damage in Polyethylene (PE) Gas Pipe

Other Standards

Keywords

damage; pipe; polyolefin; squeeze-off; Compression testing--plastics; Emergency procedures; Force; Gases; Gas pressure systems/applications; Hydraulic devices; Mechanical devices; Oversqueeze protection; Polyolefin (PO) pipe/fittings; Premature release protection; Pressure pipelines/piping systems; Safety precautions; Squeeze-off materials/applications;

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/F1041-02R08

ASTM International is a member of CrossRef.

ASTM F1041