ASTM E545-05
Historical Standard: ASTM E545-05 Standard Test Method for Determining Image Quality in Direct Thermal Neutron Radiographic Examination
SUPERSEDED (see Active link, below)
ASTM E545
1. Scope
1.1 This test method covers the use of an Image Quality Indicator (IQI) system to determine the relative quality of radiographic images produced by direct, thermal neutron radiographic examination. The requirements expressed in this test method are not intended to control the quality level of materials and components.
1.2 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in SI units are regarded to be standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E543 Specification for Agencies Performing Nondestructive Testing
E748 Practices for Thermal Neutron Radiography of Materials
E803 Test Method for Determining the L/D Ratio of Neutron Radiography Beams
E1316 Terminology for Nondestructive Examinations
E2003 Practice for Fabrication of the Neutron Radiographic Beam Purity Indicators
E2023 Practice for Fabrication of Neutron Radiographic Sensitivity Indicators
Keywords
beam purity indicator; direct method; image quality indicator; neutron radiography; sensitivity indicator; Thermal neutron radiographic testing; Beam purity indicator; Image analysis--radiographic testing; Neutron radiographic testing; Quality control (QC)--radiographic testing; Radiographic examination; Sensitivity indicator;
ICS Code
ICS Number Code 19.100 (Non-destructive testing)
DOI: 10.1520/E0545-05
ASTM International is a member of CrossRef.
