ASTM E517-00(2006)
Historical Standard: ASTM E517-00(2006) Standard Test Method for Plastic Strain Ratio r for Sheet Metal
SUPERSEDED (see Active link, below)
ASTM E517
1. Scope
1.1 This test method covers special tension testing for the measurement of the plastic strain ratio, r , of sheet metal intended for deep-drawing applications.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E6 Terminology Relating to Methods of Mechanical Testing
E8 Test Methods for Tension Testing of Metallic Materials
E83 Practice for Verification and Classification of Extensometer Systems
E92 Test Method for Vickers Hardness of Metallic Materials
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
drawability; earing tendency; plastic strain ratio; r ; r value; Ductility--metals/alloys; Metals and metallic materials; Plastic strains; Sheet metal; Steel sheet;
ICS Code
ICS Number Code 77.040.10 (Mechanical testing of metals)
DOI: 10.1520/E0517-00R06
ASTM International is a member of CrossRef.
