ASTM E228

Scope

1.1 This test method covers the determination of the linear thermal expansion of rigid solid materials over the temperature range of -180 to 900°C using vitreous silica push-rod or tube dilatometers.

1.2 For this purpose, a rigid solid is defined as a material that, at test temperature and under the stresses imposed by instrumentation, has a negligible creep or elastic strain rate, or both, regarding significantly affecting the precision of thermal-length change measurements. This includes metals, ceramics, refractories, glasses, rocks and minerals, graphites, plastics, cements, mortars, woods, and fiber, and other reinforced matrix composites.

1.3 Many materials and certain material applications require that detailed preconditioning and specific thermal test schedules be followed for the correct evaluation of thermal expansion. Since a general test method cannot cover all specific requirements, details of this nature should be contained in the relevant material specification.

1.4 The precision of this comparative test method is greater than that of other push-rod dilatometery (for example, Test Method D696) and thermomechanical analysis (for example, Test Method E831) techniques but is significantly lower than that of absolute methods such as interferometry (for example, Test Method E289). It is generally applicable to materials having linear expansion coefficients above 5 [mu]m/m[dot]K and can be used for lower expansion coefficient materials for which a sufficient length of specimen is available.

1.5 Computer- or electronic-based instrumentation, techniques, and data analysis systems equivalent to this test method can be used. Users of the test method are expressly advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user to determine the necessary equivalency prior to use. In the case of dispute only, the manual procedures described herein are to be considered valid.

1.6 The values stated in SI units are to be regarded as the standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Cement; Ceramic materials; High modulus fibrous composites; Length; Linear changes/linearity; Minerals; Mortar-cement mortar; Plastics (general); Plastic sheet and film; Refractories (general); Reinforced thermosetting plastics; Rock; Solid phase materials; Temperature tests; Thermoplastics; Thermosetting plastics; Vitreous silica dilatometer; Wood products; linear thermal expansion of solid materials (over temperature range from; -180 to 900°C), using vitreous silica dilatometers, test,; Glass; Paste; linear thermal expansion of solid materials (over temperature rangefrom; -180 to 900°C), using vitreous silica dilatometers, test,; Metals and metallic materials; linear thermal expansion of solid materials(over temperature range from; -180 to 900°C), using vitreous silica dilatometers, test,; Thermal expansion/contraction-linear; solid materials, with vitreous silica dilatometer, test,;Order Form

ICS Code

ICS Number Code 49.025.05 (Ferrous alloys in general)

DOI: 10.1520/E0228-95