ASTM E2254-03
Historical Standard: ASTM E2254-03 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
SUPERSEDED (see Active link, below)
ASTM E2254
1. Scope
1.1 This test method describes the calibration or performance confirmation for the storage modulus scale of a commercial or custom built dynamic mechanical analyzer (DMA) over the temperature range of -100 to 300C using reference materials in the range of 1 to 200 GPa.
1.2 Electronic instrumentation or automatic data analysis systems or treatments equivalent to this test method may be used.
1.3 SI units are the standard.
1.4 There is no ISO standard equivalent to this test method.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D638 Test Method for Tensile Properties of Plastics
E473 Terminology Relating to Thermal Analysis and Rheology
E698 Test Method for Arrhenius Kinetic Constants for Thermally Unstable Materials Using Differential Scanning Calorimetry and the Flynn/Wall/Ozawa Method
E1142 Terminology Relating to Thermophysical Properties
E2425 Test Method for Loss Modulus Conformance of Dynamic Mechanical Analyzers
Keywords
calibration; conformity; dynamic mechanical analysis; storage modulus; Calibration--laboratory analysis instrumentation; Conformity; Dynamic mechanical analysis (DMA); Storage modulus
ICS Code
ICS Number Code 17.020 (Metrology and measurement in general)
DOI: 10.1520/E2254-03
ASTM International is a member of CrossRef.
