1. Scope

1.1 This guide describes data required as input for mathematical fire models.

1.2 Guidelines are presented on how the data can be obtained.

1.3 The emphasis in this guide is on compartment zone fire models.

1.4 The values stated in SI units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C177 Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus

C518 Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus

D835 Specification for Refined Benzene-485

D2395 Test Methods for Specific Gravity of Wood and Wood-Based Materials

D3417 Test Method for Enthalpies of Fusion and Crystallization of Polymers by Differential Scanning Calorimetry (DSC)

D5865 Test Method for Gross Calorific Value of Coal and Coke

E176 Terminology of Fire Standards

E408 Test Methods for Total Normal Emittance of Surfaces Using Inspection-Meter Techniques

E472 Practice for Reporting Thermoanalytical Data

E537 Test Method for The Thermal Stability of Chemicals by Differential Scanning Calorimetry

E793 Test Method for Enthalpies of Fusion and Crystallization by Differential Scanning Calorimetry

E906 Test Method for Heat and Visible Smoke Release Rates for Materials and Products Using a Thermopile Method

E967 Test Method for Temperature Calibration of Differential Scanning Calorimeters and Differential Thermal Analyzers

E968 Practice for Heat Flow Calibration of Differential Scanning Calorimeters

E1321 Test Method for Determining Material Ignition and Flame Spread Properties

E1354 Test Method for Heat and Visible Smoke Release Rates for Materials and Products Using an Oxygen Consumption Calorimeter

E1623 Test Method for Determination of Fire and Thermal Parameters of Materials, Products, and Systems Using an Intermediate Scale Calorimeter (ICAL)

E2058 Test Methods for Measurement of Synthetic Polymer Material Flammability Using a Fire Propagation Apparatus (FPA)

E2257 Test Method for Room Fire Test of Wall and Ceiling Materials and Assemblies

Keywords

air/fuel ratio; combustion efficiency; convective heat transfer coefficient; data for fire models; density; emissivity; entrainment coefficient; fire model; flame extinction coefficient; flame spread parameter; heat of combustion; heat of gasification; heat of pyrolysis; rate of heat release; ignition temperature; mass loss rate; material properties; production rate of species; pyrolysis temperature; specific heat; thermal conductivity; and thermal inertia;

ICS Code

ICS Number Code 13.220.01 (General standards related to fire protection)

DOI: 10.1520/E1591-00

ASTM International is a member of CrossRef.