ASTM E1169-07
Historical Standard: ASTM E1169-07 Standard Practice for Conducting Ruggedness Tests
SUPERSEDED (see Active link, below)
ASTM E1169
1. Scope
1.1 This practice covers conducting ruggedness tests. The purpose of a ruggedness test is to identify those factors that strongly influence the measurements provided by a specific test method and to estimate how closely those factors need to be controlled.
1.2 This practice restricts itself to designs with two levels per factor. The designs require the simultaneous change of the levels of all of the factors, thus permitting the determination of the effects of each of the factors on the measured results.
1.3 The system of units for this practice is not specified. Dimensional quantities in the practice are presented only as illustrations of calculation methods. The examples are not binding on products or test methods treated.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E456 Terminology Relating to Quality and Statistics
E1325 Terminology Relating to Design of Experiments
E1488 Guide for Statistical Procedures to Use in Developing and Applying Test Methods
F2082 Test Method for Determination of Transformation Temperature of Nickel-Titanium Shape Memory Alloys by Bend and Free Recovery
Keywords
foldover; fractional factorial design; half-normal plot; Plackett-Burman; ruggedness; screening design;
ICS Code
ICS Number Code 19.020 (Test conditions and procedures in general)
DOI: 10.1520/E1169-07
ASTM International is a member of CrossRef.
