ASTM E11-04
Historical Standard: ASTM E11-04 Standard Specification for Wire Cloth and Sieves for Testing Purposes
SUPERSEDED (see Active link, below)
ASTM E11
1. Scope
1.1 This specification covers the requirements for design and construction of testing sieves using a medium of woven wire cloth mounted in a frame for use in testing for the classification of materials according to designated particle size (See Note 1 and Note 2), and wire cloth, meeting the specifications of , to be designated test grade wire cloth. All subsequent references to wire cloth shall mean test grade wire cloth. Methods for checking testing sieves and wire cloth for conformance to this specification are included in the annex.
Note 1--Complete instructions and procedures on the use and calibration of testing sieves are contained in ASTM STP447B . Note that sieve analysis results from two testing sieves of the same sieve designation may not be the same because of the variances in sieve opening permitted by this specification. To minimize the differences in sieve analysis results, the use of testing sieves matched on a performance basis is suggested. ASTM STP447B also contains a list of all published ASTM standards on sieve analysis procedures for specific materials or industries. This list may be referenced to obtain statements of precision and bias for sieve analysis of specific materials.Note 2--For other types of sieves, see Specification E323 and Specification E161.
1.2 The values stated in SI units shall be considered standard for the dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames.
1.3 The following precautionary statement refers only to the test method portion, Annex A1, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C430 Test Method for Fineness of Hydraulic Cement by the 45-m (No. 325) Sieve
E161 Specification for Precision Electroformed Sieves
E323 Specification for Perforated-Plate Sieves for Testing Purposes
E1638 Terminology Relating to Sieves, Sieving Methods, and Screening Media
E2016 Specification for Industrial Woven Wire Cloth
E2427 Test Method for Acceptance by Performance Testing for Sieves
Federal Standard
Fed.Std.No.123 Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.Military Standard
MIL-STD-129 Marking for Shipment and StorageISO Standard
ISO3310-1 Test Sieves--Technical Requirements and Testing - Part 1: Test Sieves of Metal Wire Cloth Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
aperture; calibration sieve; compliance sieve; inspection sieve; opening; particle size; sieve; sieve analysis; sieve cloth; sieve designation; test sieve; woven wire test sieve cloth; Laboratory apparatus--specifications; Particle analysis; Particle size characterization; Sieve analysis; Sieves (wire cloth)--specifications; Test grade wire cloth/sieve; Testing methods--laboratory instrumentation;
ICS Code
ICS Number Code 19.120 (Particle size analysis. Sieving)
DOI: 10.1520/E0011-04
ASTM International is a member of CrossRef.
