1. Scope

1.1 This specification covers a procedure for evaluating metal devices used for wood-to-wood, wood-to-concrete, wood-to-concrete masonry, and wood-to-steel connections. This method is intended for use with devices used to connect joists, beams, and girders together. These devices are commonly described as joist hangers.

1.2 This specification describes test methods for evaluating the capacities of joist hangers subject to vertical and torsional loading.

1.3 This specification provides a method of assigning allowable loads to joist hangers based on measured strength and deformation characteristics. Information obtained by the provisions of this specification is applicable to design when using the Allowable Stress Design method.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C31/C31M Practice for Making and Curing Concrete Test Specimens in the Field

C39/C39M Test Method for Compressive Strength of Cylindrical Concrete Specimens

C1314 Test Method for Compressive Strength of Masonry Prisms

D9 Terminology Relating to Wood and Wood-Based Products

D2395 Test Methods for Specific Gravity of Wood and Wood-Based Materials

D3737 Practice for Establishing Allowable Properties for Structural Glued Laminated Timber (Glulam)

D4442 Test Methods for Direct Moisture Content Measurement of Wood and Wood-Base Materials

D5055 Specification for Establishing and Monitoring Structural Capacities of Prefabricated Wood I-Joists

D5456 Specification for Evaluation of Structural Composite Lumber Products

D7438 Practice for Field Calibration and Application of Hand-Held Moisture Meters

E4 Practices for Force Verification of Testing Machines

E8 Test Methods for Tension Testing of Metallic Materials

E575 Practice for Reporting Data from Structural Tests of Building Constructions, Elements, Connections, and Assemblies

F606 Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

F1575 Test Method for Determining Bending Yield Moment of Nails

Other Standards

Keywords

connections; connectors; connectors for wood; hangers; hanger allowable loads; hanger capacities; hanger test; hanger testing; joist hangers; metal connectors; structural connectors; wood connections; wood connectors; wood to wood connectors;

ICS Code

ICS Number Code 91.190 (Building accessories)

DOI: 10.1520/D7147-05

ASTM International is a member of CrossRef.