ASTM D6557-10
Historical Standard: ASTM D6557-10 Standard Test Method for Evaluation of Rust Preventive Characteristics of Automotive Engine Oils
SUPERSEDED (see Active link, below)
ASTM D6557
1. Scope
1.1 This test method covers a Ball Rust Test (BRT) procedure for evaluating the anti-rust ability of fluid lubricants. The procedure is particularly suitable for the evaluation of automotive engine oils under low-temperature, acidic service conditions.
1.2 Information Letters are published occasionally by the ASTM Test Monitoring Center (TMC) to update this test method. Copies of these letters can be obtained by writing the center.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Exceptions Where there is no direct equivalent, such as the units for screw threads, national pipe threads/diameters, and tubing size.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 7.1.1-7.1.3 and 8.2.1.1.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D4175 Terminology Relating to Petroleum, Petroleum Products, and Lubricants
D5844 Test Method for Evaluation of Automotive Engine Oils for Inhibition of Rusting (Sequence IID)
Keywords
Ball Rust Test; corrosion; engine oil; rust;
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D6557-10
ASTM International is a member of CrossRef.
