ASTM D6437-05
Historical Standard: ASTM D6437-05 Standard Test Method for Polyurethane Raw Materials: alkalinity in Low-Alkalinity Polyols (Determination of CPR values of Polyols)
SUPERSEDED (see Active link, below)
ASTM D6437
1. Scope
1.1 This test method covers measuring alkalinity in low-alkalinity (0.002 meq/g basicity) polyols. This alkalinity is often expressed as CPR (controlled polymerization rate) of polyether polyols. This test method is not applicable to amine-based polyols.
1.2 The values stated in SI units are to be regarded as the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no similar or equivalent ISO standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D883 Terminology Relating to Plastics
E180 Practice for Determining the Precision of ASTM Methods for Analysis and Testing of Industrial and Specialty Chemicals
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
alkalinity; basicity; CPR; polyether polyol; polyol; polyurethane; prepolymer; raw materials; test method; titration; urethane; Acidity, alkalinity, pH--plastics; CPR (controlled polymerization rate); Polyether polyols; Polyols; Polyurethane raw materials--polyols; Prepolymers; Titration;
ICS Code
ICS Number Code 83.040.01 (Raw materials for rubber and plastics in general)
DOI: 10.1520/D6437-05
ASTM International is a member of CrossRef.
