1. Scope

1.1 This specification covers the material requirements for preformed elastomeric strip seals and the corresponding steel locking edge rail used in expansion joint sealing. The scope of this specification is limited to preformed non-reinforced strip seals that mechanically lock into structural steel locking lugs. The sealing element can consist of a single layer strip or have multiple webs depending on individual project requirements. The structural steel locking edge rail shall be anchored into the structure in accordance with the purchaser's specific details. While the scope of this specification is limited to the materials used in fabrication of strip sealing systems, it is recommended that a practical means of testing the watertightness aspects of the individual systems either in the field or at a testing laboratory be developed. When used on highway bridges, limits on maximum joint opening and minimum steel thicknesses need to be addressed.

1.2 The values stated in the inch-pound system shall be considered as standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A36/A36M Specification for Carbon Structural Steel

A572/A572M Specification for High-Strength Low-Alloy Columbium-Vanadium Structural Steel

A588/A588M Specification for High-Strength Low-Alloy Structural Steel, up to 50 ksi [345 MPa] Minimum Yield Point, with Atmospheric Corrosion Resistance

D395 Test Methods for Rubber Property--Compression Set

D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

D471 Test Method for Rubber Property--Effect of Liquids

D518 Test Method for Rubber Deterioration--Surface Cracking

D573 Test Method for Rubber--Deterioration in an Air Oven

D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment

D2240 Test Method for Rubber Property--Durometer Hardness

D2628 Specification for Preformed Polychloroprene Elastomeric Joint Seals for Concrete Pavements

D4070 Specification for Adhesive Lubricant for Installation of Preformed Elastomeric Bridge Compression Seals in Concrete Structures

Other Document.

Keywords

adhesive-lubricant; elastomeric; expansion joint; joint sealing; locking edge rails; preformed elastomer; strip seals; vulcanized elastomer;

ICS Code

ICS Number Code 83.140.50 (Seals)

DOI: 10.1520/D5973-97

ASTM International is a member of CrossRef.