ASTM D5849-95(2000)e1
Historical Standard: ASTM D5849-95(2000)e1 Standard Test Method for Evaluating Resistance of Modified, Bituminous Roofing Membranes to Cyclic Joint Displacement
SUPERSEDED (see Active link, below)
1. Scope
1.1 This test method determines the effect of constant cyclic displacement on polymer-modified bituminous membrane specimens. In this test method, a relatively low travel rate of cycling is used and the material is tested for a specified number of cycles under conditions of increased amplitude or lower temperature.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D41 Specification for Asphalt Primer Used in Roofing, Dampproofing, and Waterproofing
D1079 Terminology Relating to Roofing and Waterproofing
D5147 Test Methods for Sampling and Testing Modified Bituminous Sheet Material
Canadian General Standards Board Method
CGSB37-GP-56M Standard for Membrane, Modified, Bituminous, Prefabricated, and Reinforced for RoofingKeywords
cyclic displacement; fatigue; polymer modified bituminous membrane;
ICS Code
ICS Number Code 91.120.30 (Waterproofing)
DOI: 10.1520/D5849-95R00E01
ASTM International is a member of CrossRef.
