ASTM D5428-08
Historical Standard: ASTM D5428-08 Standard Practice for Evaluating the Performance of Inflatable Restraint Modules
SUPERSEDED (see Active link, below)
ASTM D5428
1. Scope
1.1 This practice describes the procedures and conditions used to evaluate the physical performance of inflatable restraint modules and module components during and after deployment.
1.2 The physical performance characteristics that may be obtained by this practice are internal cushion pressures determined by instrumentation, cushion geometries determined by high-speed photography, and material integrity determined by visual inspection.
1.3 This practice is applicable to driver and passenger side inflatable restraint modules.
1.4 Procedures and apparatus other than those stated in this practice may be used by agreement between the purchaser and the supplier with the specific deviations from the practice acknowledged in the report.
1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D123 Terminology Relating to Textiles
D6799 Terminology Relating to Inflatable Restraints
Federal Standard
CFR49 Code of Federal RegulationsSAE Standard
J211 Instrumentation for Impact TestKeywords
airbag; cushion; deployment; dynamic performance; inflatable restraint; module ;
ICS Code
ICS Number Code 43.040.80 (Crash protection systems and restraint systems)
DOI: 10.1520/D5428-08
ASTM International is a member of CrossRef.
