ASTM D4385-95
Historical Standard: ASTM D4385-95 Standard Practice for Classifying Visual Defects in Thermosetting Reinforced Plastic Pultruded Products
SUPERSEDED (see Active link, below)
ASTM D4385
1. Scope
1.1 This practice covers acceptance criteria for visual acceptance of thermosetting reinforced plastic pultruded rods, bars, shapes, and sheets.
1.2 This practice presents definitions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection.
1.3 This practice also categorizes different inspection requirements for three grades of product quality.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no similar or equivalent ISO standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D3647 Practice for Classifying Reinforced Plastic Pultruded Shapes According to Composition
D3917 Specification for Dimensional Tolerance of Thermosetting Glass-Reinforced Plastic Pultruded Shapes
Keywords
pultrusion; structural shapes; visual; Acceptance criteria/testing; Classification (standards)--plastics; Defects--plastics; Pultrusion; Reinforced thermosetting plastics (RTP); Resins; Shrinkage--plastics; Structural plastics; Visual examination--plastics;
ICS Code
ICS Number Code 83.120 (Reinforced plastics)
DOI: 10.1520/D4385-95
ASTM International is a member of CrossRef.
