ASTM D4084-05
Historical Standard: ASTM D4084-05 Standard Test Method for Analysis of Hydrogen Sulfide in Gaseous Fuels (Lead Acetate Reaction Rate Method)
SUPERSEDED (see Active link, below)
ASTM D4084
1. Scope
1.1 This test method covers the determination of hydrogen sulfide (H 2 S) in gaseous fuels. It is applicable to the measurement of H 2 S in natural gas, liquefied petroleum gas (LPG), substitute natural gas, and mixtures of fuel gases. Air does not interfere. The applicable range is 0.1 to 16 parts per million by volume (ppm/v) (approximately 0.1 to 22 mg/m 3 ) and may be extended to 100 % H 2 S by manual or automatic volumetric dilution.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1193 Specification for Reagent Water
D1914 Practice for Conversion Units and Factors Relating to Sampling and Analysis of Atmospheres
D2420 Test Method for Hydrogen Sulfide in Liquefied Petroleum (LP) Gases (Lead Acetate Method)
D3609 Practice for Calibration Techniques Using Permeation Tubes
D7166 Practice for Total Sulfur Analyzer Based On-line/At-line for Sulfur Content of Gaseous Fuels
E2165 Practice for Establishing an Uncertainty Budget for the Chemical Analysis of Metals, Ores, and Related Materials
Keywords
gaseous fuels; hydrogen sulfide; lead acetate;
ICS Code
ICS Number Code 75.160.30 (Gaseous fuels)
DOI: 10.1520/D4084-05
ASTM International is a member of CrossRef.