ASTM D4040-99
Historical Standard: ASTM D4040-99 Standard Test Method for Viscosity of Printing Inks and Vehicles by the Falling-Rod Viscometer
SUPERSEDED (see Active link, below)
ASTM D4040
1. Scope
1.1 This test method covers the procedure for determining the falling-rod viscosity of printing inks, vehicles, and similar liquids that are essentially nonvolatile and unreactive under ordinary room conditions.
1.2 For printing inks, which are typically non-Newtonian, this test method is applicable in the apparent viscosity range of about 10 to 300 P at a shear rate of 2500 s -1 . For Newtonian liquids, the applicable viscosity range is about 10 to 1000 P (1 P = 0.1 Pa[dot]s).
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)
D6606 Test Method for Viscosity and Yield of Vehicles and Varnishes by the Duke Viscometer
Other Standards
ISO12644 Graphic Technology--Determination of rheological properties of paste inks and vehicles by the falling rod viscometerKeywords
apparent viscosity; falling-rod viscometers ; inks; non-Newtonianism; power law viscosity; printing inks; shortness; vehicles; viscometers; viscosity; yield value; Calibration--paints/related coatings analysis instrumentation; Falling rod viscometer; Glazing compounds/applications; Newtonian fluids; Non-Newtonian coatings; Power law; Printing inks/vehicles; Shear testing--paints/related coatings/materials; Sliding scale calibration graph; Viscometers--falling rod; Viscosity--paints/related coatings/materials;
ICS Code
ICS Number Code 87.080 (Inks. Printing inks)
DOI: 10.1520/D4040-99
ASTM International is a member of CrossRef.
