ASTM D3896-85(2001)
Historical Standard: ASTM D3896-85(2001) Standard Practice for Rubber From Synthetic Sources-Sampling
SUPERSEDED (see Active link, below)
ASTM D3896
1. Scope
1.1 This practice covers a uniform procedure for sampling lots of solid synthetic rubbers. Raw synthetic rubber generally is marketed in bales or packages of various sizes.
1.2 A procedure for determining the acceptability of lots of synthetic rubber is given. This procedure is based on a variables sampling plan.
1.3 The sample size is based on the assumption of a visually homogeneous material. If obvious heterogeneity exists, the number of samples shall be increased.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ANSI Standard
Z1.9 Sampling Procedures and Tables for Inspection by Variables for Percent Defective Available from the American National Standards Institute, 25 W. 43rd St., 4th Floor, New York, NY 10036.Keywords
sampling; synthetic rubber; Chemical analysis--rubber chemicals/materials; Raw rubber; Rubber sampling; Synthetic rubber
ICS Code
ICS Number Code 83.060 (Rubber)
DOI: 10.1520/D3896-85R01
ASTM International is a member of CrossRef.
