ASTM D3617-02
Historical Standard: ASTM D3617-02 Standard Practice for Sampling and Analysis of New Built-Up Roof Membranes
SUPERSEDED (see Active link, below)
ASTM D3617
1. Scope
1.1 This practice is a guide for removing specimens from new built-up bituminous roof membranes before the application of flood coating and top surfacing for determining the approximate quantities of the components and the possible presence of moisture, or dry spots between plies, in the field. Components may consist of:
1.1.1 Insulation, when part of the roof membrane system,
1.1.2 Plies of roofing felt,
1.1.3 Interply layers of bituminous material, and
1.1.4 Top coating, if present, before any surfacing aggregate has been applied.
1.2 The values stated in SI (metric) units are to be regarded as the standard.
1.3 This standard is applicable to 910-mm (36-in.) wide felt rolls and does not apply to metric-sized (that is, 1000-mm [39 3/8-in.] wide) felt rolls.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D226 Specification for Asphalt-Saturated Organic Felt Used in Roofing and Waterproofing
D227 Specification for Coal-Tar-Saturated Organic Felt Used in Roofing and Waterproofing
D250 Standard Specification for Asphalt-Saturated Asbestos Felt Used in Roofing and Waterproofing
D2178 Specification for Asphalt Glass Felt Used in Roofing and Waterproofing
D2626 Specification for Asphalt-Saturated and Coated Organic Felt Base Sheet Used in Roofing
D3158 Specification for Asphalt Saturated and Coated Organic Felt Used in Roofing
D3378 Specification for Asphalt-Saturated and Coated Asbestos Felt Base Sheet Used in Roofing
Keywords
felts; insulation; interply bituminous material; lap spacing; moisture; plies; surfacing; top coating;
ICS Code
ICS Number Code 91.100.50 (Binders. Sealing materials)
DOI: 10.1520/D3617-02
ASTM International is a member of CrossRef.
