ASTM D3595-02
Historical Standard: ASTM D3595-02 Standard Specification for Polychlorotrifluoroethylene (PCTFE) Extruded Plastic Sheet and Film
SUPERSEDED (see Active link, below)
ASTM D3595
1. Scope
1.1 This specification covers extruded sheet and film in thicknesses from 0.015 to 0.25 mm (0.0006 to 0.01 in.).
1.2 The values stated in SI units shall be regarded as the standard.
1.3 The following precautionary statement pertains only to the test methods portion, Section 9 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no ISO equivalent specification to this specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D374 Test Methods for Thickness of Solid Electrical Insulation
D618 Practice for Conditioning Plastics for Testing
D882 Test Method for Tensile Properties of Thin Plastic Sheeting
D883 Terminology Relating to Plastics
D1204 Test Method for Linear Dimensional Changes of Nonrigid Thermoplastic Sheeting or Film at Elevated Temperature
D1430 Classification System for Polychlorotrifluoroethylene (PCTFE) Plastics
D1600 Terminology for Abbreviated Terms Relating to Plastics
D3892 Practice for Packaging/Packing of Plastics
F1249 Test Method for Water Vapor Transmission Rate Through Plastic Film and Sheeting Using a Modulated Infrared Sensor
Keywords
chlorofluorocarbon plastics; copolymer; extruded PCTFE; fluorocarbon polymer; fluoropolymers; homopolymer; PCTFE; PCTFE film; PCTFE sheet; polychlorotrifluoroethylene;
ICS Code
ICS Number Code 83.140.10 (Films and sheets)
DOI: 10.1520/D3595-02
ASTM International is a member of CrossRef.
