ASTM D3018/D3018M-10
Historical Standard: ASTM D3018/D3018M-10 Standard Specification for Class A Asphalt Shingles Surfaced with Mineral Granules
SUPERSEDED (see Active link, below)
ASTM D3018 / D3018M
1. Scope
1.1 This specification covers granule-surfaced asphalt roofing shingles that meet the conditions for Class A fire test, behavior on heating, and wind testing.
1.2 Shingles meeting this specification are intended to be applied with a headlap of not less than 51 mm [2 in.].
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D228 Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
D1079 Terminology Relating to Roofing and Waterproofing
D3161 Test Method for Wind-Resistance of Asphalt Shingles (Fan-Induced Method)
E108 Test Methods for Fire Tests of Roof Coverings
Keywords
asphalt shingles; Class A Shingles; granule-surface shingles; wind resistance: Asphalt roofing materials--specifications; Mineral-surfaced roofing--specifications; Roofing materials/applications--specifications; Shingles--specifications ;
ICS Code
ICS Number Code 91.100.15 (Mineral materials and products)
DOI: 10.1520/D3018_D3018M-10
ASTM International is a member of CrossRef.
