ASTM D2809-94(1999)
Historical Standard: ASTM D2809-94(1999) Standard Test Method for Cavitation Corrosion and Erosion-Corrosion Characteristics of Aluminum Pumps With Engine Coolants
SUPERSEDED (see Active link, below)
ASTM D2809
1. Scope
1.1 This test method covers the evaluation of the cavitation corrosion and erosion-corrosion characteristics of aluminum automotive water pumps with coolants.
Note 1-During the development of this test method, it was found that results obtained when testing two-phase coolants did not correlate with results from field tests. Therefore, the test method cannot be recommended as being a significant test for determining cavitation effects of two-phase coolants.1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 5.2.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1176 Practice for Sampling and Preparing Aqueous Solutions of Engine Coolants or Antirusts for Testing Purposes
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
Keywords
aluminum; automotive; cavitation corrosion; engine coolant; erosion-corrosion; pumps; test; Aluminum; Aluminum alloys--corrosion by engine coolants; Automotive engine pumps; Cavitation erosion/corrosion; Containers--metal; Corrosion--Al/Al alloys; Corrosion--cavitation erosion/corrosion; Corrosion--engine coolants; Engine coolant corrosivity; Erosion-corrosion; Pumps;
ICS Code
ICS Number Code 23.080 (Pumps)
DOI: 10.1520/D2809-94R99
ASTM International is a member of CrossRef.
