ASTM D2340-03
Historical Standard: ASTM D2340-03 Standard Test Method for Peroxides in Styrene Monomer
SUPERSEDED (see Active link, below)
ASTM D2340
1. Scope
1.1 This test method covers the determination of the peroxide content of styrene monomer.
1.2 The following applies to all specified limits in this test method: for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off 'to the nearest unit' in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1193 Specification for Reagent Water
D3437 Practice for Sampling and Handling Liquid Cyclic Products
D6809 Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
Other Documents
OSHARegulations,29CF paragraphs 1910.1000 and 1910.1200 Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.Keywords
peroxide content; peroxide in styrene; styrene;
ICS Code
ICS Number Code 71.080.15 (Aromatic hydrocarbons)
DOI: 10.1520/D2340-03
ASTM International is a member of CrossRef.
