Significance and Use

Test Method D 2058 is useful for determining the effect of repeated drycleaning on the appearance of the decorative coating of a zipper.

This test method is considered satisfactory for acceptance testing of commercial shipments because the method has been used extensively in the trade for acceptance testing.

If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, the test samples should be used that are as homogeneous as possible, that are drawn from the material from which the disparate test results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias.

The method(s) in the standard along with those in Test Methods D 2051 , D 2052 , D 2053 , D 2054 , D 2057 , D 2059 , D 2060 , D 2061 , and D 2062 are a collection of proven test methods. They can be used as aids in the evaluation of zippers without the need for a thorough knowledge of zippers. The enumerated test methods do not provide for the evaluation of all zipper properties. Besides those properties measured by means of the enumerated test methods there are other properties that may be important for the satisfactory performance of a zipper. Test methods for measuring those properties have not been published either because no practical methods have yet been developed or because a valid evaluation of the information resulting from existing unpublished methods requires an intimate and thorough knowledge of zippers.

1. Scope

1.1 This test method covers the determination of the durability of the enamel or other decorative coating of zippers when subjected to drycleaning.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D123 Terminology Relating to Textiles

D2050 Terminology Relating to Fasteners and Closures Used with Textiles

D2051 Test Method for Durability of Finish of Zippers to Laundering

D2052 Test Method for Colorfastness of Zippers to Drycleaning

D2053 Test Method for Colorfastness of Zippers to Light

D2054 Test Method for Colorfastness of Zipper Tapes to Crocking

D2057 Test Method for Colorfastness of Zippers to Laundering

D2059 Test Method for Resistance of Zippers to Salt Spray (Fog)

D2060 Test Methods for Measuring Zipper Dimensions

D2061 Test Methods for Strength Tests for Zippers

D2062 Test Methods for Operability of Zippers

AATCC Method

Keywords

drycleaning; durability; zipper; Drycleaning materials/processes/tests; Durability--consumer products; Enamel coatings; Zipper finish durability;

ICS Code

ICS Number Code 61.040 (Headgear. Clothing accessories. Fastening of clothing)

DOI: 10.1520/D2058-03R09

ASTM International is a member of CrossRef.

ASTM D2058