ASTM D1414-94(2003)
Historical Standard: ASTM D1414-94(2003) Standard Test Methods for Rubber O-Rings
SUPERSEDED (see Active link, below)
ASTM D1414
1. Scope
1.1 These test methods describe the procedures for determining the physical properties of O-rings and changes in these properties due to aging.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D297 Test Methods for Rubber Products--Chemical Analysis
D395 Test Methods for Rubber Property--Compression Set
D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension
D471 Test Method for Rubber Property--Effect of Liquids
D573 Test Method for Rubber--Deterioration in an Air Oven
D865 Test Method for Rubber--Deterioration by Heating in Air (Test Tube Enclosure)
D1329 Test Method for Evaluating Rubber Property--Retraction at Lower Temperatures (TR Test)
D1415 Test Method for Rubber Property--International Hardness
D2240 Test Method for Rubber Property--Durometer Hardness
D4483 Practice for Evaluating Precision for Test Method Standards in the Rubber and Carbon Black Manufacturing Industries
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Aerospace Standard
AS568A O-ring Sizes Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.Keywords
aging tests; o-rings; physical properties;Aging--rubber; Compression testing--rubber; Corrosivity; Elongation--rubber; Engineering applications; Hardness (indentation)--rubber; Liquids immersion--effect on rubber; Mold shrinkage; O-rings; Quality control (QC)--rubber; Rubber property analysis; Rubber rings; Rubber seals; Shrinkage--rubber; Tensile properties/testing--rubber/relatged materials;
ICS Code
ICS Number Code 21.140 (Seals, glands)
DOI: 10.1520/D1414-94R03
ASTM International is a member of CrossRef.
