ASTM D1000-99
Historical Standard: ASTM D1000-99 Standard Test Method for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications
SUPERSEDED (see Active link, below)
ASTM D1000
1. Scope
1.1 These test methods cover procedures for testing pressure-sensitive adhesive-coated tapes to be used as electrical insulation and are classified as follows:
1.1.1 Class 1 -Non-elastomeric backings made from materials such as: Paper, flat or creped, Fabric, uncoated or coated, Cellulose ester films, Polyethylene terephthalate (polyester) films, Fluorocarbon polymer films, Composite filament films, Polyamide films, Polyimide films, and Combinations thereof.
1.1.2 Class 2 -Elastomeric backings that are characterized by both high stretch and substantial recovery made from materials such as: Vinyl chloride and co-polymers, Vinylidene chloride and co-polymers, and Polyethylene and co-polymers.
Note 1-Laminates of Class 1 and Class 2 backings should be tested according to Class 1 test methods.1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 3.
1.3 The procedures appear in the sections indicated:
Paper, flat or creped, Fabric, uncoated or coated, Cellulose ester films, Polyethylene terephthalate (polyester) films, Fluorocarbon polymer films, Composite filament films, Polyamide films, Polyimide films, and Combinations thereof.1.4 The values stated in inch-pound units are the standard, unless otherwise noted. If a value for measurement is followed by a value in SI units in parentheses, the second value may only be approximate. The first stated value is the requirement.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A167 Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Strip
D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
D257 Test Methods for DC Resistance or Conductance of Insulating Materials
D295 Test Methods for Varnished Cotton Fabrics Used for Electrical Insulation
D374 Test Methods for Thickness of Solid Electrical Insulation
D1711 Terminology Relating to Electrical Insulation
D3487 Specification for Mineral Insulating Oil Used in Electrical Apparatus
D5032 Practice for Maintaining Constant Relative Humidity by Means of Aqueous Glycerin Solutions
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
IEC Standard
IEC 60454-3 Specification for Pressure-Sensitive Adhesive Tapes for Electrical Purposes Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
accelerated aging; adhesion; adhesive; backing; bond strength; breaking strength; conditioning; dielectric breakdown; electrical insulating tape; elongation; flagging; flammability; high temperature testing; insulation resistance; length; low temperature testing; oil resistance; pressure-sensitive adhesive tape; puncture resistance; thermosetting; thickness; unwind force; voltage; width;
ICS Code
ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
DOI: 10.1520/D1000-99
ASTM International is a member of CrossRef.
