1. Scope

1.1 This specification covers three strength grades of finely ground granulated blast-furnace slag for use as a cementitious material in concrete and mortar.

Note 1-The material described in this specification may be used for blending with portland cement to produce a cement meeting the requirements of Specification C 595 or as a separate ingredient in concrete or mortar mixtures. The material may also be useful in a variety of special grouts and mortars, and when used with an appropriate activator, as the principal cementitious material in some applications.

Note 2-Information on technical aspects of the use of the material described in this specification is contained in Appendixes X1, X2, and X3. More detailed information on that subject is contained in ACI Report 226. 1R.

1.2 The values stated in SI units are to be regarded as standard.

1.3 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)

C114 Test Methods for Chemical Analysis of Hydraulic Cement

C125 Terminology Relating to Concrete and Concrete Aggregates

C150 Specification for Portland Cement

C185 Test Method for Air Content of Hydraulic Cement Mortar

C188 Test Method for Density of Hydraulic Cement

C204 Test Methods for Fineness of Hydraulic Cement by Air-Permeability Apparatus

C430 Test Method for Fineness of Hydraulic Cement by the 45-m (No. 325) Sieve

C441 Test Method for Effectiveness of Pozzolans or Ground Blast-Furnace Slag in Preventing Excessive Expansion of Concrete Due to the Alkali-Silica Reaction

C452 Test Method for Potential Expansion of Portland-Cement Mortars Exposed to Sulfate

C465 Specification for Processing Additions for Use in the Manufacture of Hydraulic Cements

C595 Specification for Blended Hydraulic Cements

C1012 Test Method for Length Change of Hydraulic-Cement Mortars Exposed to a Sulfate Solution

C1038 Test Method for Expansion of Hydraulic Cement Mortar Bars Stored in Water

D3665 Practice for Random Sampling of Construction Materials

Keywords

concrete; mortar; slag;

ICS Code

ICS Number Code 91.100.30 (Concrete and concrete products)

DOI: 10.1520/C0989-99

ASTM International is a member of CrossRef.