ASTM C964-88(2002)e1
Historical Standard: ASTM C964-88(2002)e1 Standard Guide for Lock-Strip Gasket Glazing
SUPERSEDED (see Active link, below)
ASTM C964
1. Scope
1.1 This guide covers the use of lock-strip gaskets in compliance with Specification C 542 in walls of buildings not over 15 from a vertical plane. The prime performance considerations are weather tightness against air and water infiltration, and structural integrity under wind loads. Included are terminology, design considerations, and fabrication tolerances when using lock-strip gaskets in glazing applications.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C542 Specification for Lock-Strip Gaskets
C716 Specification for Installing Lock-Strip Gaskets and Infill Glazing Materials
C864 Specification for Dense Elastomeric Compression Seal Gaskets, Setting Blocks, and Spacers
C963 Specification for Packaging, Identification, Shipment, and Storage of Lock-Strip Gaskets
C1036 Specification for Flat Glass
E283 Test Method for Determining Rate of Air Leakage Through Exterior Windows, Curtain Walls, and Doors Under Specified Pressure Differences Across the Specimen
E330 Test Method for Structural Performance of Exterior Windows, Doors, Skylights and Curtain Walls by Uniform Static Air Pressure Difference
E331 Test Method for Water Penetration of Exterior Windows, Skylights, Doors, and Curtain Walls by Uniform Static Air Pressure Difference
Keywords
elastomeric; glazing; lock-strip gasket; sealant ;
ICS Code
ICS Number Code 91.060.50 (Doors and windows)
DOI: 10.1520/C0964-88R02E01
ASTM International is a member of CrossRef.