ASTM C645-08
Historical Standard: ASTM C645-08 Standard Specification for Nonstructural Steel Framing Members
SUPERSEDED (see Active link, below)
ASTM C645
1. Scope
1.1 This specification covers nonstructural steel framing members in interior construction assemblies.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI (metric) values given in parentheses are provided for information purposes only.
1.3 The following safety hazards caveat pertains only to the test methods portion, Sections 9 and 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A653/A653M Specification for Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-Coated (Galvannealed) by the Hot-Dip Process
A1003/A1003M Specification for Steel Sheet, Carbon, Metallic- and Nonmetallic-Coated for Cold-Formed Framing Members
C11 Terminology Relating to Gypsum and Related Building Materials and Systems
C475/C475M Specification for Joint Compound and Joint Tape for Finishing Gypsum Board
C754 Specification for Installation of Steel Framing Members to Receive Screw-Attached Gypsum Panel Products
C1002 Specification for Steel Self-Piercing Tapping Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Wood Studs or Steel Studs
C1396/C1396M Specification for Gypsum Board
AISI Standards
S200 North American Standard for Cold-Formed Steel Framing General Provisions, 2007 EditionICC-ES Document
ICC-ES-AC86 Acceptance Criteria for Steel Studs and Gypsum-Board Interior Nonload-Bearing WallsComplete ConstructionAC86Approved July 1995 (Editorially revised September 2005) (Formerly ICBO AC86 dated July 1995)Keywords
furring channels; grid suspension systems; gypsum board; runners; screws; section properties; spinout; studs;
ICS Code
ICS Number Code 91.060.10 (Walls. Partitions. Facades)
DOI: 10.1520/C0645-08
ASTM International is a member of CrossRef.
