ASTM C564-08
Historical Standard: ASTM C564-08 Standard Specification for Rubber Gaskets for Cast Iron Soil Pipe and Fittings
SUPERSEDED (see Active link, below)
ASTM C564
1. Scope
1.1 This specification covers preformed rubber gaskets used to seal joints in cast iron soil pipe and fittings.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The following safety hazards caveat pertains only to the test methods section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The committee with jurisdiction over this standard is not aware of another comparable standard for materials covered in this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A644 Terminology Relating to Iron Castings
C1277 Specification for Shielded Couplings Joining Hubless Cast Iron Soil Pipe and Fittings
D395 Test Methods for Rubber Property--Compression Set
D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension
D471 Test Method for Rubber Property--Effect of Liquids
D573 Test Method for Rubber--Deterioration in an Air Oven
D624 Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment
D1415 Test Method for Rubber Property--International Hardness
D2240 Test Method for Rubber Property--Durometer Hardness
D3677 Test Methods for Rubber--Identification by Infrared Spectrophotometry
Other Documents
CISPI310 Specification for couplings for use in connection with hubless cast iron soil pipe and fittings for sanitary and storm drain, waste, and vent piping applications Available from Cast Iron Soil Pipe Institute (CISPI), http://www.cispi.org.Keywords
cast iron; fittings; gaskets; pipe; rubber;
ICS Code
ICS Number Code 23.040.80 (Seals for pipe and hose assemblies)
DOI: 10.1520/C0564-08
ASTM International is a member of CrossRef.
