Abstract

This guide covers the wet sieve analysis of ceramic whiteware clays. This guide is intended for use in testing shipments of clay as well as for plant control tests. The apparatus to be used include stirring device and sieves. The following procedure shall be followed in the analysis of the ceramic whiteware clays: transferring of duplicate portions of the dried clay sample; agitating of the slurry by means of a mechanical stirrer to ensure complete separation of clay from nonplastic impurities; transferring of the slaked and stirred sample, without loss, to the finest sieve to be employed in the test; washing of the residue remaining on the finest sieve into the pan; nesting the top sieve on the pan, which shall contain a certain amount of clear water; refilling of the pan with the proper amount of water, then nesting the top sieve and its residue on the pan; carefully blotting each sieve on its underside with a soft, damp sponge, and placing the sieve either in a drying oven or under infrared lamps until thoroughly dry; nesting the dried residues and sieves in the proper order, with due care to prevent dusting of the residues; and separating the nested sieves and carefully brushing the residue from each onto a weighing paper.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This guide covers the wet sieve analysis of ceramic whiteware clays. This guide is intended for use in testing shipments of clay as well as for plant control tests.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C322 Practice for Sampling Ceramic Whiteware Clays

E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

Keywords

clay; sieve analysis; wet sieve;

ICS Code

ICS Number Code 81.060.10 (Raw materials)

DOI: 10.1520/C0325-07

ASTM International is a member of CrossRef.

ASTM C325