ASTM C1298-95(2001)
Historical Standard: ASTM C1298-95(2001) Standard Guide for the Design and Construction of Brick Liners for Industrial Chimneys
SUPERSEDED (see Active link, below)
ASTM C1298
1. Scope
1.1 This guide covers procedures for the design, construction, and serviceability of brick liners for industrial chimneys. The structural design criteria are applicable to vertical masonry cantilever structures supported only at their base, either by a foundation, a concrete pedestal, or by some means from the outer concrete shell. Excluded from direct consideration are single-wythe, sectional brick linings that are supported on a series of corbels cast in the outer chimney shell.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C395 Specification for Chemical-Resistant Resin Mortars
C466 Specification for Chemically Setting Silicate and Silica Chemical-Resistant Mortars
C980 Specification for Industrial Chimney Lining Brick
E111 Test Method for Youngs Modulus, Tangent Modulus, and Chord Modulus
E447 Test Method for Compressive Strength of Laboratory Constructed Masonry Prisms
ACI Standard
30788 Practice for the Design and Construction of Cast-In-Place Reinforced Concrete Chimneys Available from American Concrete Institute (ACI), P.O. Box 9094, Farmington Hills, MI 48333-9094, http://www.aci-int.org.ASCE Standard
ASCE 7-88 Minimum Design Loads for Buildings and Other Structures (Formerly ANSI A58.1) Available from American Society of Civil Engineers (ASCE), 1801 Alexander Bell Dr., Reston, VA 20191, http://www.asce.org.Other Standard
1991 Uniform Building Code, International Conference of Building Code Officials, California Available from International Code Council (ICC), 5203 Leesburg Pike, Suite 600, Falls Church, VA 22041-3401, http://www.intlcode.org.Keywords
chemical resistant mortar; chimney liner brick; construction requirements; counterweight system; design; details; leaning liner; masonry strength; pressurization; stability; stress; target wall ;
ICS Code
ICS Number Code 81.080 (Refractories); 91.060.40 (Chimneys, shafts, ducts)
DOI: 10.1520/C1298-95R01
ASTM International is a member of CrossRef.
