1. Scope

1.1 This practice covers the technical training and experience of laboratory testing personnel and identifies the minimum technical requirements for laboratory equipment used in testing of hydraulic cement as prescribed by ASTM.

1.2 This practice provides minimum criteria for evaluating the capability of a laboratory to perform chemical or physical tests listed in the various specifications on hydraulic cement (see Note 1).

Note 1 Relevant hydraulic cement specifications are Specifications C 91, C 150, C 595, C 845, and Performance Specification C 1157.

1.3 The SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C91 Specification for Masonry Cement

C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)

C114 Test Methods for Chemical Analysis of Hydraulic Cement

C115 Test Method for Fineness of Portland Cement by the Turbidimeter

C125 Terminology Relating to Concrete and Concrete Aggregates

C150 Specification for Portland Cement

C185 Test Method for Air Content of Hydraulic Cement Mortar

C187 Test Method for Amount of Water Required for Normal Consistency of Hydraulic Cement Paste

C191 Test Methods for Time of Setting of Hydraulic Cement by Vicat Needle

C204 Test Methods for Fineness of Hydraulic Cement by Air-Permeability Apparatus

C219 Terminology Relating to Hydraulic Cement

C230/C230M Specification for Flow Table for Use in Tests of Hydraulic Cement

C266 Test Method for Time of Setting of Hydraulic-Cement Paste by Gillmore Needles

C305 Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency

C451 Test Method for Early Stiffening of Hydraulic Cement (Paste Method)

C595 Specification for Blended Hydraulic Cements

C845 Specification for Expansive Hydraulic Cement

C1157 Performance Specification for Hydraulic Cement

C1506 Test Method for Water Retention of Hydraulic Cement-Based Mortars and Plasters

E4 Practices for Force Verification of Testing Machines

Other Documents

Keywords

hydraulic cement; laboratory evaluation ;

ICS Code

ICS Number Code 71.040.10 (Chemical laboratories. Laboratory equipment); 91.100.10 (Cement. Gypsum. Lime. Mortar)

DOI: 10.1520/C1222-05A

ASTM International is a member of CrossRef.