ASTM C1216-92(1997)
Historical Standard: ASTM C1216-92(1997) Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
SUPERSEDED (see Active link, below)
1. Scope
1.1 This test method is a laboratory procedure that determines the adhesion and cohesion performance of one-part elastomeric, solvent release sealants at high and low temperatures by the extension and compression of test specimens.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 2.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C33 Specification for Concrete Aggregates
C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
C150 Specification for Portland Cement
C717 Terminology of Building Seals and Sealants
Aluminum Association Standard
DAF-45 Designation System for Aluminum Finishes Available from Aluminum Association, 900 19th St. NW, Washington, DC 20006.Keywords
adhesion; cohesion; joint movement; sealant; solvent-release;
ICS Code
ICS Number Code 83.140.50 (Seals)
DOI: 10.1520/C1216-92R97
ASTM International is a member of CrossRef.
