ASTM C1197-92(1997)
Historical Standard: ASTM C1197-92(1997) Standard Test Method for In Situ Measurement of Masonry Deformability Properties Using the Flatjack Method
SUPERSEDED (see Active link, below)
ASTM C1197
1. Scope
1.1 This test method describes an in situ method for determining the deformation properties of existing unreinforced solid-unit masonry. This test method concerns the measurement of in-situ masonry deformability properties in existing masonry by use of thin, bladder-like flatjack devices that are installed in saw cut mortar joints in the masonry wall. This test method provides a relatively non-destructive means of determining masonry properties.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E74 Practice of Calibration of Force-Measuring Instruments for Verifying the Force Indication of Testing Machines
Keywords
flatjack; in situ; masonry; nondestructive evaluation; Compression testing--masonry/mortar; Nondestructive evaluation (NDE)--concrete/masonry; Compressive modulus; Deformability; Flatjack method; In-situ inspection/analysis; Masonry units
ICS Code
ICS Number Code 91.060.10 (Walls. Partitions. Facades)
DOI: 10.1520/C1197-92R97
ASTM International is a member of CrossRef.
