Abstract

This specification covers round, zinc-aluminum mischmetal (Zn-5Al-MM) alloy-coated, steel core wire with three classes of this coating used for mechanical reinforcement in the manufacture of aluminum conductors, steel reinforced. The base metal shall be steel produced by the open-hearth, electric furnace, or basic oxygen process. The steel shall conform to the required chemical composition carbon, manganese, phosphorus, sulfur and silicon. The coated steel core wire shall conform to the required tensile and elongation properties. The wire shall be capable of being wrapped in a close helix around a cylindrical mandrel. For the purpose of calculating mass per unit length, cross sections, etc, the density of the material shall be taken. Wire diamter, mass and permissible variations shall be measured.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers round, zinc 5 % aluminum-mischmetal (Zn 5Al MM) alloy-coated, steel core wire with three classes of Zn 5Al MM coating used for mechanical reinforcement in the manufacture of aluminum conductors, steel reinforced (ACSR).

1.2 This specification covers wire of diameter from 0.0500 to 0.1900 in. or 1.27 to 4.82 mm, inclusive.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A90/A90M Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

A370 Test Methods and Definitions for Mechanical Testing of Steel Products

A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products

B193 Test Method for Resistivity of Electrical Conductor Materials

B750 Specification for GALFAN (Zinc-5 % Aluminum-Mischmetal) Alloy in Ingot Form for Hot-Dip Coatings

E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E47 Test Methods for Chemical Analysis of Zinc Die-Casting Alloys

E1277 Test Method for Chemical Analysis of Zinc-5 % Aluminum-Mischmetal Alloys by ICP Emission Spectrometry

Other Standard

Keywords

coated steel wire; mischmetal alloy-coated steel wire; steel core-wire; steel wire; zinc-5% aluminum; AACSR (aluminum-alloy conductors, steei reinforced); Aluminum-coated steel wire--specifications; Aluminum electrical conductors--specifications; Aluminum-mischmetal (Al-MM) alloy; Mischmetal alloy-coated steel wire--specifications; Steel-reinforced electrical conductors--specifications; Zinc-aluminum-mischmetal alloy (Zn-Al-MM); Zinc-coated steel wire--specifications;

ICS Code

ICS Number Code 29.060.01 (Electrical wires and cables in general); 29.060.20 (Cables)

DOI: 10.1520/B0802_B0802M-10

ASTM International is a member of CrossRef.

ASTM B802 / B802M