Abstract

Specification covers masonry joint reinforcements fabricated from cold-drawn steel wires. It specifies that joint reinforcement consists of longitudinal wires welded to cross wires. Wire used in the manufacture of masonry joint reinforcement shall be round. Masonry joint reinforcement shall then be assembled by automatic machines or by other suitable mechanical means that will assure accurate spacing and alignment of all members of the finished product. Longitudinal and cross wires shall be securely connected at every intersection by an electric-resistance welding process and then it shall be deformed. Tension, weld shear strength, and bend tests shall be performed on the samples. When corrosion protection of joint reinforcement has been provided, it shall be either zinc coated mill or hot-dip galvanized.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers masonry joint reinforcement fabricated from cold-drawn steel wire. Joint reinforcement consists of longitudinal wires welded to cross wires.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A82/A82M Specification for Steel Wire, Plain, for Concrete Reinforcement

A152 Specification for Wrought Iron Rivets and Rivet Rounds

A185/A185M Specification for Steel Welded Wire Reinforcement, Plain, for Concrete

A496/A496M Specification for Steel Wire, Deformed, for Concrete Reinforcement

A580/A580M Specification for Stainless Steel Wire

A641/A641M Specification for Zinc-Coated (Galvanized) Carbon Steel Wire

A1064/A1064M Specification for Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete

Keywords

cross wires; deformed; galvanized wire; hot-dipped galvanized; joint reinforcement; ladder type; longitudinal wires; tensile properties; truss type; weld shear strength: Masonry joint reinforcement; Masonry units--specifications;

ICS Code

ICS Number Code 91.080.30 (Masonry)

DOI: 10.1520/A0951_A0951M-11

ASTM International is a member of CrossRef.

ASTM A951 / A951M